Features and maintenance of oilless dental compressor

Do you know the characteristics of oilless dental compressor? Do you know how to maintain it? I believe that many of my friends don't understand this very well, so let me briefly introduce it to you.

Features of oilless dental compressor:

1. Low noise

The output pressure is stable and stable, which greatly reduces noise pollution. Suitable for testing, laboratory facilities, laboratories, scientific research institutes, environmental protection, sanitation and epidemic prevention, etc.

2. No oil, no water

The compressor handles the phenomenon of output gas, oil and water. It is also equipped with a water outlet to discharge the filtered water and artificial turf from the gas storage tank in time.

3. Steady-state current

The oilless dental compressor uses advanced pressure equipment and outputs a constant current regulator to make laboratory instruments such as atomic absorption test reproduce imported geomembrane.

4. Long service life

The oilless dental compressor has begun to warm up the equipment. The machine is equipped with an external protector, and the pot is sprayed internally. This not only makes the compressor reasonable use, but also has versatility and long service life.

5. Simple operation

The oilless dental compressor is very convenient to use, no need to check it all the time.

Maintenance knowledge of oilless dental compressor:

1. The machine is working intermittently and the air supply is insufficient. Reason 1: The voltage is insufficient and there is a buzzing sound when starting. 2. Starting capacitor leakage, the compressor head can still start when the capacitor leakage, but the speed slows down and the current increases. Due to the high current, the machine head heats up quickly, and soon the machine head will protect the machine and stop automatically. At this time, replace with new accessories, but please note that the UF number must be the same, too large or too small can not be used.

2. The noise becomes louder when the machine is running. When this phenomenon occurs, first check whether the accessories are loose and whether the running current is normal. If it is normal, the machine head must be replaced. The use environment of the equipment should avoid dusty places as much as possible, disconnect the power supply regularly and remove the dust on the surface and the two-head fan blades. The excessive noise is due to the wear of the four motor bearings and the damage to the leather cup. Replace the relevant accessories.

3. Before the machine is running, place the air pressure of the storage battery at zero to start. When the machine is energized, it can be seen that the speed of the machine head is slow, accompanied by a buzzing sound, and the current increases. The reason is that the one-way valve is dirty and stuck. One end is connected to the air outlet pipe of the machine head, and the other end is connected to the gas cylinder. Its function is to pour the gas into the gas cylinder but not come out, and its inside is a spring and film. If the film gets stuck in dirt, it will cause reverse air leakage. When the machine head is started for the second time, it cannot be started due to high voltage 2. At this time, a wrench must be used to open and clean the rear valve cover of the one-way valve.

The above is the whole content of the characteristics and maintenance of the oilless dental compressor introduced by the editor. I hope it can be helpful to you. If you need this, please come to negotiate business.